JetPack 4.4.1 Installation for DSBOX-N2
Jetson Nano 21 February 2021

First of all, connect the recovery (between installer pc & DSBOX-N2's recovery usb), ethernet & power connection of your DSBOX-N2. Open a terminal on your installer pc then type "watch lsusb".

When DSBOX-N2's power connector plugged in,

You should see "NVidia Corp." title in the terminal.

 

 

Next, set your configurations in the Nvidia SDK Manager.

 

 

Accept the license agreement and continue to step 3.

 

 

Nvidia SDK Manager asks your password to installation. Fill it and continue.

 

 

After all packages have been downloaded, Jetson OS will be installed on the Jetson Nano.

 

 

The SDK Manager asks your DSBOX-N2's username and password. We will continue from here after the second part.

 

 

On the second part, copy your dtb file to kernel/dtb folder at the end of the post. The full path of the folder is (for JetPack 4.4.1):

  • ~/nvidia/nvidia_sdk/JetPack_4.4.1_Linux_JETSON_NANO/Linux_for_Tegra/kernel/dtb


     

    Put your DSBOX-N2 in recovery mode and check it from the terminal.

     

     

    Open another terminal and type these commands:

    • cd ~/nvidia/nvidia_sdk/JetPack_4.4.1_Linux_JETSON_NANO/Linux_for_Tegra/kernel/dtb
    • sudo ./flash.sh -r -k DTB jetson-nano-emmc mmcblk0p1

    Once the dtb file is successfully updated, configure your DSBOX-N2's Ubuntu installation progress (language, keyboard type, location, username & password etc.).

     

    After ubuntu installation copy the kernel image which attached below to the DSBOX-N2 from host pc with scp command.

    Connect to your DSBOX-N2 via ssh then execute the below commands.


       

      Finally, complete the SDK Manager installation progress. Type your username and password then click "Install".

       

       

       

      Thanks for reading.