1- The basic perspective on DSBOX-N2
2- The definition of each connector
3- The pinout of I/O connector
Hardware: DSBOX-N2
OS: Jetpack 4.5
Software: All JetPack versions
Forecr’s DSBOX-N2 is industrial Box PC platform for deep learning based on edge analytics and IIOT applications. It has versatile NVIDIA® Jetson Nano™ module that enables to run multiple neural networks in parallel for applications.
The DSBOX-NX2 implements 14 pins GPIO Expansion connector which has 4 digital output pins, 4 digital input pins. It is located on the rear side of the box. The mating connector is “1790535” produced by Phoenix Contact.
The NVIDIA® Jetson Nano™ module will output video via the DSBOX-N2 vertical HDMI connector that is HDMI 2.0 capable. It is located on the rear side of the box and the mating connector is HDMI Type-A Cable.
The DSBOX-N2 incorporates 2 USB 3.1 Type-A connectors with a 2A current limit per connector. It is located on the rear side of the box. The mating part is USB Type-A cable.
The DSBOX-N2 implements RJ-45 ethernet connector for internet communication. RJ-45 connector is connected directly to the NVIDIA Jetson Nano module. It is located on the rear side of the box. The mating connector is RJ-45 Ethernet cable.
The DSBOX-N2 implements a Micro USB connector to allow to install or upgrade the operating system. It is located on the front side. The mating connector is USB 2.0 Micro-B or Micro-AB Cable.
The DSBOX-N2 implements a Micro USB connector to access the module by using serial connection. It is located on the front side. The mating connector is USB 2.0 Micro-B or Micro-AB Cable. This connector is also compatible with SIM card interface.
The DSBOX-N2 implements a power button for energize the platform. It is located on the front side. A Power Supply capable of 50W or more is required to operate the DSBOX-N2 with all peripherals running at their respective maximum rating.
The DSBOX-N2 implements a recovery pushbutton. Recovery button should be pressed with reset button at the same time. After released reset button, recovery button should be pressed a little bit more (min. 250 ms). It is located on the front side. It is recommended to use needle-like material.
The DSBOX-N2 implements a reset button. It is recommended to use needle-like material and recommended to use needle-like material.
The DSBOX-N2 implements a micro SD Card and nano SIM card connector together. The bottom part is used for micro SD card and the upper part is used for nano SIM card connector. It is located on the front side of the box.
Thank you for reading our blog post.
