figure of DSBOARD-NX2 with NVIDIA Jetson Xavier NX module

How to Mount Wi-Fi Card into M.2 Key-E Slot on DSBOARD-NX2?

Jetson Nano | Jetson TX2 NX | Jetson Xavier NX

16 September 2021

Hardware: DSBOARD-NX2

Wi-Fi Card: Intel Dual Band Wireless-AC

In this blog post, we will explain how to mount a Wi-Fi card into the M.2 Key-E Slot of DSBOARD-NX2.

M.2 Key-E slot is placed under the module as seen below. So, if you have a module connected, first eject the module by removing the screws and lift both ends of module connector.

Then, carefully plug the pins of Wi-Fi card with the contacts of the connector at a 30-degree angle.

Push down the SSD to the bottom and mount the screw while holding the Wi-Fi card down. 

You can check if the Wi-Fi card is mounted correctly by running either of following commands.


Here, the Wi-Fi card is shown as Intel Corporation Device.


Here, the Wi-Fi card is shown as Intel Corp.

Thank you for reading our blog post.